How To Use (Using The Remote Controller) - Bosch 660 EF User Manual

5.4

How to Use (Using the remote controller)

Setting and Using the Water Heater
The illustration below shows the remote
i
controller display. What is actually dis-
played depends on how the water heater
is set.
USA REMOTE CONTROL
(PART N# BRC01US)
Fig. 40
1 Burner On Indicator
2 Priority Indicator
3 Temperature Setting
4 Setting Buttons
5 Power ON/OFF Button
6 Flow Meter Alarm Set Button
• Burner ON Indicator
When burning, the indicator is lit
• Priority Indicator
When this indicator is lit,the hot water temperature-
can be set
• Temperature Setting
(Ex.: 110°F (40°C))
• Flow Meter Setting
The display will flash after hitting the flow meter alarm
set button
• Error Code
A number will flash if a failure occurs
• Setting Buttons
For setting the hot water temperature, the flow meter
alarm, and other settings
• Power ON/OFF Button
For turning theheater on and off
• Flow Meter Alarm Set Button
For setting the flowmeter alarm.
Before use, remove the protective sheet
i
from the remote controller surface.
6 720 644 063
CANADA REMOTE CONTROL
(PART N# BRC01CA)
Starting with the Power OFF
1. Check that electrical power is connected
The temperature will be displayed on the remote control
thermostat.
Danger: To prevent scalding
Hot Water Heater temperatures over
125°F (52°C) can cause severe burns
instantly or death from scalding.
Danger: To prevent scalding
Children, disabled and elderly are at the
highest risk of being scalded. Feel water
temperature before bathing or shower-
ing.Temperature limiting valves are avail-
able (installer supplied).
Danger: To prevent scalding
When setting the unit to130°F (60°C) or
higher, the temperature display will flash
for 10 seconds and emit a tone as a high
temperature warning.
Danger: To prevent scalding
Take caution when using the unit again
after setting to 125°F (52°C) or higher.
Always check the set temperature be-
fore use.
Operation instructions
35