Registration Of Remote Control (Accessory No 7 709 003 756); Remote Control Operation (Accessory No 7 709 003 756) - Bosch Therm 6000 S Installation And Operating Instructions Manual

Table of Contents

Advertisement

12 | Operating instructions
4.6
Registration of remote control (accessory no
7 709 003 756)
Only a qualified technician is allowed to install the additional
PCB that is supplied with the remote. Only after installation of
PCB the registration can be made.
The registration of the remote control must be done near the
appliance.
Hot water tap closed.
Turn OFF the appliance (Fig. 4, [1]).
▶ Press and hold the programming key (Fig. 4, [3]), press
ON/OFF button (Fig. 4, [1]) to connect the appliance.
Release programming key only when LCD displays "188"
The LCD displays the signal "P2".
▶ Press key
, until it displays the signal "P3".
▶ Press programming key again for about 1 second.
LCD panel displays one number and one rotating digit.
The number represents the remote control which is to be
registered, the first remote control will be registered with
number "0", the second with number "1" and so on.
▶ Test the remote control in front of the electronic box by
simultaneously pressing the
Fig. 15
Activate new control
▶ Press both keys until the LCD panel stops flashing and
shows the indication "00".
▶ Press ON/OFF button (Fig. 4, [1]) to disconnect the
appliance .
Remote control is now deactivated.
Press the ON/OFF button to turn ON the
remote control and it's ready to work.
6 720 800 095 (2015/11)
and
control keys.
4.7
Remote control operation (accessory no 7
709 003 756)
This appliance fulfills European directive requirements 1999/
5/CEE (R&TTE) and corresponds to the specifications
described in the cor-responding CE certificate of proof.
▶ Press buttons
and
temperature.
Fig. 16
Remote control (temperature selection)
NOTE: up to 6 remote controls can be
programmed for one single water heater,
each with a range distance of 30m.
CAUTION:
▶ Remote control is not a toy - do not allow
children to play with the remote control
unit.
Batteries replacement
▶ Remove the 2 screw from the remote control back.
▶ Open the cover.
▶ Remove the old batteries and correctly place the new ones.
▶ Close the remote control assuring that both screws are
tighten screwed.
CAUTION:
▶ remote control can be used under the
shower
must not be forced
Precautions when using the batteries
Do not dispose of batteries as domestic waste. Take them
to appropriate collecting places for recycling.
Do not insert flat batteries.
Only use the type of batteries indicated.
in order to reach requested
, however, it's immersion
.
Therm 6000S

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents