Panasonic KX-TDE100 Features Manual page 270
Pure ip-pbx telephone systems
Hide thumbs
Also See for KX-TDE100:
- Programming manual (1018 pages) ,
- Pc programming manual (982 pages) ,
- Features manual (470 pages)
Table of Contents
Advertisement
1.24.2 Voice Mail Features
5.22 [3-8-1] VM(DTMF) Group—System Settings
®
VM DTMF Command—Recording Message
®
VM DTMF Command—Listening Message
®
VM DTMF Command—Switching to AA
®
VM DTMF Command—Switching to VM
Switching to VM
Switching to AA
Recording message
Listening message
Note
H = Mailbox Number
3.
VM Service
a.
FWD to a Mailbox of the VPS
The PBX sends a mailbox number of the corresponding extension to the VPS when a call is forwarded
from an extension to the VPS. Therefore the caller can leave a message for the called extension without
knowing the mailbox number.
[FWD to the VPS Sequence Selection]
If an extension user sets FWD to the VPS, any incoming call will be forwarded to the VPS. It is also
possible to send the AA command, even in the VM service mode, when calls are forwarded so that the
caller can be directed to an extension rather than a mailbox. This can be performed by
selecting "AA" through system programming.
® 5.22 [3-8-1] VM(DTMF) Group—System Settings—
Parameter
Answer by Mailbox
(Default)
AA
None
b.
Intercept Routing to a Mailbox of the VPS
The PBX sends a mailbox number of the corresponding extension to the VPS when a trunk call is
intercepted from an extension to the VPS. Therefore the caller can leave a message for the called
extension without knowing the mailbox number.
[Intercept Routing to the VPS Sequence Selection]
If an extension user sets Intercept Routing to the VPS, the intercepted trunk calls will be redirected to
the VPS.
It is also possible to send the AA command, even in the VM service mode, when calls are intercepted
so that the caller can be directed to an extension rather than a mailbox. This can be performed by
selecting "AA" through system programming.
® 5.22 [3-8-1] VM(DTMF) Group—System Settings—
Sequence
270
Feature Guide
Transmitted Command
In AA Service Mode
Switching to VM command +
Recording message command
(#6 + H [H = Mailbox No.])
Switching to AA command (#8)
(DTMF commands are not sent. Work with default of the VPS.)
Command (Default)
#6
#8
H
H
Others—FWD to the VPS Sequence
In VM Service Mode
Recording message command
(H [H = Mailbox No.])
Switching to AA command (#8)
Others—Intercept Routing to the VPS
Advertisement
Table of Contents
