Honeywell GSMX Installation And Setup Manual page 16

GSMX Installation and Setup Guide
PROMPTS ENTRY
5
Change
Password?
(Y/N)_
6
Enter
Password
7
Verify
Password
8
Exit Prog.
Mode?
(Y/N)_
9
Device
Mode
(ECP)_
OPTIONS
[Y], [N] If a password has already been
assigned, this prompt appears
after pressing [N] at the
"Program Device?" prompt.
Press [Y] if you want to change
the password.
NOTE: To clear an existing
password, without entering a new
one, answer [Y] to the "Change
Password?" prompt, then press
the [Enter] key when prompted
for the new password and its
confirmation.
[0-9, A-F, This prompt is displayed if [Y]
N, S, T, X, was pressed in Prompt 4 or 5.
Y]
Enter a 4-digit password
(0-9, A-F, N, S, T, X, Y).
[0-9, A-F, Re-enter the password as
N, S, T, X, confirmation.
Y]
If the password doesn't match the
first entry, the following is
displayed followed by the "Exit
Prog. Mode?" prompt:
Verify Not OK
PSWD not created
Otherwise, the "Exit Prog. Mode?"
prompt is displayed directly.
[Y], [N] Exits program mode.
[ESC] Press [N] to go back to Prompt 3.
Press [ESC] to load factory
defaults.
Refer to the Exiting the
Programming Mode topic.
• ECP Press the [space] key to scroll
through the modes of
• 4204
Press [ENTER] to select the
Emu
desired mode.
• Two
4204s
– 14 –
DESCRIPTION
operation.