Exiting Programming Mode; Setting Factory Defaults - Honeywell IntelliPath Series Installation And Setup Manual

Section 3: Programming the Communicator

Exiting Programming Mode

To exit the programming mode, press [N] in response to the "REVIEW?" prompt. Then press [Y]
to the "Exit Prog Mode?" prompt. Upon exiting, the root file is updated to log the changes made.
A message is displayed telling the user that this step is being executed. When complete, the
message "DONE" is displayed to indicate the file was successfully uploaded.
If critical configuration changes were made, such as the mode of operation, the communicator
will reset to ensure that the programming features are enabled.
If the file is not successfully uploaded, one of the following prompts will be displayed. Follow the
steps shown below until the upload is successful.
Display
Cannot Upload
Try Again? Y/N_
Failed to Update
Root File!

Setting Factory Defaults

To reset the programming options to factory-default values, press [ESC] at the "Exit Prog Mode?"
prompt.
Set Default?
Y/N_
If you press [Y], all programmed values are reset to the original factory settings. PLEASE NOTE
THAT THIS WILL ERASE ANY PASSWORD THAT MAY HAVE BEEN ENTERED. After pressing
[Y], the Create Password prompt appears (see Prompt 4).
Description
Communicator is not yet initialized.
Network problem, or you answered
"N" to "Cannot Upload Try Again?"
prompt.
Press [Y] to reset factory default values.
Press [N] to cancel this function.
15
What to do
Wait for RSSI LEDs to be lit.
Press [Y].
Initiate the Force Server Update
Command by pressing the [0] key; refer to
Section 5: Programmer Keyboard
Commands.