GSMX Installation and Setup Guide
Monitor and control their security system from a website
Receive e-mail and text message notifications of system events
Control the system and receive confirmations using text messages
Dealers can enroll their customers for "Remote Services" by using the
AlarmNet Direct website. Once enabled, the specific programming fields
associated with these features can be programmed into the communications
device either remotely using the AlarmNet Direct website or locally using the
7720P programming tool.
E-mail notification (Multi Mode) is intended as a convenience
for the user, and does not replace Central Station reporting of
critical events (alarms, troubles, etc.).
Testing the System
After installation the security system should be tested. Refer to the control
panel installation instructions for procedures to test the entire system.
The GSMX functions with any control panel that utilizes a Honeywell ECP
bus and supports Long Range Radio.
This device has been tested by ETL to meet the following standards:
• UL985 – Residential Fire
• UL1023 – Residential Burg
Mounting and Wiring the Module
Select a Mounting Location
When choosing a suitable mounting location, understand that it must be
mounted indoors, and for best signal strength it should be mounted
vertically. Signal strength is very important for proper operation. For most
installations, mounting the unit on the control panel provides adequate
signal strength and we suggest that this method is tried first. Especially if
the control panel is not in a basement location or in an area that contains
large metal objects.
If the control panel location does not provide adequate signal strength, then
the module can be mounted remotely.
– 3 –