Table of Contents
Advertisement
PROMPTS
64
Review? Y/N
Exiting Programming Mode
To exit the programming mode, press [N] in response to the "REVIEW?" question. Then
press [Y] to the "Exit Prog Mode?" question. Upon exiting, the message "Checking Root File
TX Path" will be displayed, and the configuration file at the server is updated to log the
changes made. When complete, the message "DONE" is displayed to indicate the file was
successfully uploaded.
If critical configuration changes were made, such as the mode of operation, the GSMHS will
reset to ensure that the programming features are enabled.
If the file is not successfully uploaded, one of the following prompts will be displayed. Follow
the steps shown below until the upload is successful.
Display
Cannot Upload
Try Again? Y/N_
Failed to Update
Root File!
Setting Factory Defaults
To reset the programming options to factory-default values, press [ESC] at the "Exit Prog
Mode?" prompt.
Set Default?
Y/N_
If you press [Y], all programmed values are reset to the original factory settings. PLEASE
NOTE THAT THIS WILL ERASE ANY PASSWORD THAT MAY HAVE BEEN ENTERED.
After pressing [Y], the Create Password prompt appears (see Prompt 4).
4204/
ZONE
ENTRY
2-4204
TRIG.
Description
GSM module is not yet initialized.
Network problem, or you
answered "N" to "Cannot Upload
Try Again?" prompt.
Press [Y] to reset factory default values.
Press [N] to cancel this function.
Section 3: Programming the GSMHS
OPTIONS
Reviewing Programming Mode Entries
[Y] =
To review the programming options (to ensure
review
that the correct entries have been made), press
[N] = exit
[Y]. The programming questions are displayed
again. Use the up/down arrow keys to scroll
through the program fields without changing
any of the values. If a value requires change,
simply type in the correct value. When the
last field is displayed, the "REVIEW?"
question again appears.
To exit the programming mode, press [N]
in response to the "REVIEW?" question, and
refer to Exiting Programming Mode below.
What to do
Wait for RSSI LEDs to be lit.
Press [Y].
Initiate the Force Server Update
command by pressing the [0] key; refer
to Section 5: Programmer Keyboard
Commands.
DESCRIPTION
3-17
Advertisement
Table of Contents
