Front Wheel Installation - Honda CB400T Shop Manual

~.
HONDA
C B 4 0 0 T
FRONT WHEEL/BRAKE/SUSPENSION
FRONT WHEEL INSTALLATION
Insert the axle through the wheel hub from
the right side.
Torque the axle nut, noting the installation
direction of the speedometer gearbox.
TORQUE SPECIFICATION:
5.0-8.0 k g m (36-58 lbs-h)
zontally, being careful not t o bend the
speedometer cable.
Position the axle holder on the fork end with
the arrow mark facing the front.
Tighten the forward nut to the specified
torque first, then tighten the rear hut to the
same torque.
TORQUE SPECIFICATION:
1.8-2.5 k g m (13-18 ibs-ftl
remove load from the front fork. Keep
Connect the speedometer cable to the speedo-
meter gearbox while rotating the wheel by
hand.
Install the brake cable and adjust the brake
(Drum type only).
With the front brake applied, pump the front
fork u p and down several times to check for
proper operation.
Recheck the installation of the axle holder
and adjust, if necessary.
Date of Issue: September, 1977
@ HONDA MOTOR CO.. LTD.
1 2 - 1 1