Rear Wheel Removal/Disassembly/Assembly; Axle Shaft Bend Inspection; Rear Wheel Bearing Play Inspection; Rear Wheel Rim Runout Inspection - Honda CB400T Shop Manual

HONDA
C B 4 0 0 T
REAR WHEELIBRAKEISUSPENSION
REAR WHEEL REMOVAL/
DISASSEMBLY /ASSEMBLY
REAR WHEEL REMOVAL
Support the motorcycle on the main stand or
a stand placed under the engine.
Disconnect the brake rod.
Pry off the cotter pin and separate the
brake torque link.
Loosen the drive chain adjusting bolts.
Remove the cotter pin and loosen the axlt
nut.
Remove the drive chain retaining clip.
Withdraw the axle and remove the rear
wheel.
A X L E SHAFT BEND INSPECTION
Set the axle in
V
blocks and read the axle
bend.
The actual axle bend is
112
of TIR. (total
indicator reading).
REAR WHEEL BEARING P L A Y
INSPECTION
Check the wheel bearing play by rotating the
wheel by hand. Replace the bearings w i t h
new ones i f they are noisy or have excessive
play.
REAR WHEEL RIM RUNOUT
INSPECTION
Check the r i m for runout b y placing the wheel
i n a truing stand. Spin the wheel by hand,
and read the runout using a dial ind.icator
gauge.
serviced and must be replaced i f the
SERVICE LIMIT:
0.2 mrn (0.008 in.)
R A D I A L A X I A L
Date of Issue: September,
1977
o
H o N D A MOTOR
co..
LTD.
13-3