Xerox Phaser 3600 Service Manual page 64

Error Messages
Jam At Top (Jam 1)
3-14
Troubleshooting Reference Table
Applicable Parts
Registration Assembly, PL1.1.12
Paper Exit Sensor, PL1.3.76
Switched Mode Power Supply
Troubleshooting Procedure Table
Step Actions and Questions
1. Clean the paper path of any
obstructions, dirt or debris.
Did this correct the problem
2. Use service diagnostics to test
the operation of the Registration
Assembly.
Does the Registration Assembly
operate correctly?
3. Use service diagnostics to test
the Exit Sensor.
Does the sensor operate
correctly?
4. Replace the Fuser Assembly
(page 7-54) and retest.
Did this correct the problem?
Wiring and Plug/Jack Map References
"Main Drive/Joint Board and Optional
Tray Wiring Diagram" on page 9-15
"Map 3- SMPS Board" on page 9-6
Yes No
Complete. Go to Step 2.
Go to Step 3. Replace the
Registration
Assembly
(page 7-41).
Go to Step 4. Replace the Exit
Sensor page 7-56
Complete. Replace the SMPS
(page 7-76).
Phaser 3600 Printer Service Manual