Brother FAX-645 Owner's Manual page 81

Remote Commands
95 Changing Fax Forwarding/
Paging Setting
1 OFF
2 Fax Forwarding
3 Paging
4 FAX FWD NO.
96 Retrieve a fax
1 Memory Status List
2 Retrieve all faxes
3 Erase fax in the memory
97 Check the receiving status
1 Document
2 VOICE
98 Change Answer Mode
1 MSG CTR
2 F/T
3 FAX
90 Exit
M E S S A G E C E N T R E ( F O R F A X - 6 8 5 M C A N D M F C - 9 6 0 M C O N L Y )
Operation Details
If you hear one long beep, the change is
accepted. If you hear three short beeps, you
cannot change it because the conditions have
not been met (Example: registering paging
number). You can register your fax forwarding
number by using 4. FAX FWD NO. (See page
9-13.) Once you have registered the number,
the FAX/MFC will change automatically to
FAXFWD:ON mode. Then retrieve a Memory
Status List by entering 9 6 1 (See page 9-12.)
to make sure that the Fax Forwarding number
you registered is correct in the List.
Enter the number of a remote FAX/MFC to
receive a report or stored fax messages. (See
page 9-12.)
If you hear one long beep, you can erase the fax
message from the memory.
You can check whether your FAX/MFC has
received any Document or VOICE messages.
If yes, you will hear one long beep. If no, you
will hear three short beeps.
If you hear one long beep, you can change the
answer mode. If you hear three short beeps,
you cannot change it. (Example: There is no
MSG CTR OGM when you want to change to
MSG CTR mode.)
After a long beep, you can exit remote control.
9 - 11