Jumper Settings; At/Atx Mode Selection; Table 4-1: Jumpers - IEI Technology KINO-DQM871 User Manual

4.6 Jumper Settings

NOTE:
A jumper is a metal bridge that is used
to close an electrical circuit. It consists
of two metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them.
To CLOSE/SHORT a jumper means
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper means removing the plastic clip
from a jumper.
Before the KINO-DQM871 is installed in the system, the jumpers must be set in
accordance with the desired configuration. The jumpers on the KINO-DQM871 are listed
in Table 4-1.
Description

AT/ATX mode selection

Clear CMOS
LVDS voltage selection
LVDS resolution selection

Table 4-1: Jumpers

4.6.1 AT/ATX Mode Selection
Jumper Label:
Jumper Type:
Jumper Settings:
Jumper Location:
Page 62
KINO-DQM871 Mini-ITX SBC
J_ATXCTL1
Switch
See Figure 4-6
See Figure 4-6
Label Type
J_ATXCTL1 Switch
J_CMOS1 Push-button
JLCD_PWR1 6-pin header
SW1 DIP switch