Single Rs-232 Cable (W/O Bracket); Figure 4-11: Single Rs-232 Cable Installation - IEI Technology KINO-DQM871 User Manual
Mini-itx sbc with 4th generation 22nm intel mobile cpu up to 16.0 gb ddr3, hdmi, lvds, displayport, vga dual gbe, sata 6gb/s, usb 3.0, dual pcie mini pcie x16, intel® amt 9.0, roh
Table of Contents
Advertisement
Step 3:
Connect the cable to the SATA disk. Connect the connector on the other end
of the cable to the connector at the back of the SATA drive. See Figure 4-10.
Step 4:
To remove the SATA cable from the SATA connector, press the clip on the
connector at the end of the cable.
4.8.2 Single RS-232 Cable (w/o Bracket)
The single RS-232 cable consists of one serial port connector attached to a serial
communications cable that is then attached to a D-sub 9 male connector. To install the
single RS-232 cable, please follow the steps below.
Step 1:
Locate the connector. The location of the RS-232 connector is shown in
Chapter 3.
Step 2:
Insert the cable connector. Insert the connector into the serial port pin header.
See Figure 4-11. A key on the front of the cable connectors ensures the
connector can only be installed in one direction.
Figure 4-11: Single RS-232 Cable Installation
Step 3:
Secure the bracket. The single RS-232 connector has two retention screws
that must be secured to a chassis or bracket.
Page 68
KINO-DQM871 Mini-ITX SBC
Step 0:
Advertisement
Table of Contents
