Setting The Announcement Time Interval - Yaesu DR-1 Operating Manual

4
Select and touch [CW ID SPEED]
The set value will change in the following sequence each time it is touched.
"16wd/min" → "18wd/min" → "20wd/min" → "22wd/min" → "24wd/min"
Tip Factory default: 20wd/min
Note When operating in the USA the CW ID SPEED setting time must not exceed 20 words per
minute when keyed by an automatic device, to comply with the FCC rule Part 97: Sec. 97.119
(b)(1) Station identification.
5
Touch [BACK]
The setting is determined and the display will return to the menu list.

Setting the announcement time interval

1
Touch [F] in the setup mode screen
The setup menu will appear.
2
Touch [ID ANNOUNCE]
The menu list will appear.
3
Select [INTERVAL]
4
Touch [▲] or [▼]
The set value will change in the following sequence each time it is touched.
"OFF" → "3min" → "5min" → "10min" → "15min" → "20min" → "30min" → "TOT"
Tip
Factory default: 10min
Note When operating in the USA the ID setting time should be ten minutes or less to comply with the
FCC rule Part 97: Sec. 97.119 (a) Station identification.
5
Touch [BACK]
The setting is determined and the display will return to the setup menu.
Setting up the Repeater
31