Appendix; Installation Of The Optional Voice Guide Unit "Fvs-2 - Yaesu DR-1 Operating Manual

Installation of the Optional Voice guide unit "FVS-2"

1.
Turn the DR-1's [POWER] switch "OFF".
2.
Disconnect all the cables from the
3.
Referring to Figure 1, remove the 4 screws from each
side and 7 screws from the top cover of the DR-1, then
remove the top cover.
4.
Referring to Figure 2, remove the 2 screws from each
side and 4 screws from the top cover of the RX-Unit,
then remove the top cover.
5.
Refer to Figure 3 for the mounting location for the FVS-
2.
6.
Push the FVS-2 (component side up) onto the pins
corresponding to its assigned mounting location on
the DR-1. Gently press the board down until it is firmly
seated on the connectors.
7.
Replace the top cover of the RX-Unit and its 8 screws.
8.
Replace the top cover of the DR-1 and 15 screws.
9.
Connect the all cables to the DR-1.

Appendix

DR-1.
Figure 1
Figure 2
Figure 3
Figure 4
35