Table of Contents
Advertisement
7. WIRELESS LAN PARAMETER SETTING
7.1.4 Parameter Setting Procedure (when using IrCOMM Protocol)
When using the IrDA interface supporting the IrCOMM, such as, IrDA interface built in a notebook PC, the
IrCOMM Protocol should be used.
PC
1. Confirm the IrDA settings of the PC in the following way.
Turn on the printer while pressing and holding the [FEED] key on the printer to start the printer in the system
mode. Hold the [FEED] key until the indicator LED starts to blink in green. Since a diagnostic test result is
automatically printed, confirm that the settings fo the IrDA interface are "IrCOMM".
NOTE : Do not press the [FEED] key after the diagnostic test printing. Doing so causes the printer to enter
another mode where printer parameters cannot be set.
2 Run the parameter setting application, "RFLAN Configuration Tool", on the PC.
Example
IrDA Interface Window
7.1 WHEN USING THE RFLAN CONFIGURATION TOOL
7-8
(Revision Date: Jan. 29, 2004)
B-SP2D Printer
EO18-33014
Advertisement
Table of Contents
