TEC B-SP2D Series Maintenance Manual page 55

4. PROGRAM DOWNLOAD
4.4.5 Installation Procedure (When using the IrCOMM supporting IrDA)
When using the IrDA interface supporting the IrCOMM, such as, IrDA interface built in a laptop PC, the
IrCOMM Protocol should be used.
1 Confirm the IrDA settings of the PC in the following way.
Turn on the printer while pressing and holding the [FEED] key on the printer to start the printer in the
system mode. Hold the [FEED] key until the indicator LED starts to blink in green. Since a diagnostic test
result is automatically printed, confirm that the settings fo the IrDA interface are "IrCOMM".
NOTE : Do not press the [FEED] key after the diagnostic test printing. Doing so causes the printer to enter
another mode where printer parameters cannot be set.
2 Run the firmware downloader, "B-SP2D RFLAN F/W Download Tool", on the PC.
3 Confirm that the settings of the downloader are as follows:
Control port of the Com Settings is IrDA: IrCOMM.
Vertual port for the IrDA is selected for the Com Settings Port.
NOTE: When the OS is Windows 2000 or Windows XP, COM port setting will be ineffective.
4 Place the PC and the printer so that their IrDA interface windows face each other. Then, click on the [Start]
button on the screen to be ready for downloading. (When the [Start] button is clicked, the printer's LED will
blink in green.)
Example
5 Download the firmware to the wireless LAN module in the printer. After downloading is completed, turn off the
printer. (Refer to Step 6 to Step 10 of Section 4.4.4.)
PC
4.4 DOWNLOAD TO THE WIRELESS LAN MODULE
IrDA Interface Window
4-15
EO18-33014
(Revision Date: Jan. 29, 2004)
B-SP2D Printer