TEC B-SP2D Series Maintenance Manual page 51

4. PROGRAM DOWNLOAD
4.4.3 Firmware Files Copy
If it ever becomes necessary to upgrade the firmware in the wireless LAN module you will be supplied with a
floppy disk containing the latest firmware revision similar to that shown below.
The files contained on the Install Kit can be copied to PC hard disk and then downloaded to the printer.
4.4.4 Installation Procedure (When using the TEC Protocol)
1 Connect the ACT-IR220+ to the serial port of the PC.
2 Confirm the IrDA settings of the PC in the following way.
Turn on the printer while pressing and holding the [FEED] key on the printer to start the printer in the system
mode. Hold the [FEED] key until the indicator LED starts to blink in green. Since a diagnostic test result is
automatically printed, confirm that the settings of the IrDA interface are "TEC 19200".
NOTE: Do not press the [FEED] key after the diagnostic test printing. Doing so causes the printer to enter
another mode where printer parameters cannot be set.
Example
PC
4-11
(Revision Date: Jan. 29, 2004)
4.4 DOWNLOAD TO THE WIRELESS LAN MODULE
B-SP2D RFLAN Module
FIRMWARE V1.0
RFLAN-FIRM-V100.BIN
31st August 2003
V001.000
Copyright2003
TOSHIBA TEC CORPORATION
All Rights Reserved
ACT-IR220+
EO18-33014