Table of Contents
Advertisement
7. WIRELESS LAN PARAMETER SETTING
4. By following the messages on the screen, perform the installation.
5. When the installation was completed successfully, the end screen appears. Click on the [Finish] button to
end the installation.
7.1.3 Parameter Setting Procedure (when using TEC Protocol)
When using the TEC Protocol, ACTiSYS ACT-IR220L+ (IrDA Com-Port Serial Adapter) is required.
1.Connect the ACT-IR220L+ to the serial port of the PC.
Example
2. Confirm the IrDA settings of the printer in the following way.
Turn on the printer while pressing and holding the [FEED] key on the printer to start the printer in the system
mode. Hold the [FEED] key until the indicator LED starts to blink in green. Since a diagnostic test result is
automatically printed, confirm that the settings fo the IrDA interface are "TEC 19200".
NOTE:
Do not press the [FEED] key after the diagnostic test printing. Doing so causes the printer to enter
another mode where printer parameters cannot be set.
PC
7-2
(Revision Date: Jan. 29, 2004)
7.1 WHEN USING THE RFLAN CONFIGURATION TOOL
ACT-IR220+
EO18-33014
Advertisement
Table of Contents
