22: Chorus (Chorus); 23: Flanger (Flanger) - Roland JD-XA Parameter Manual

22: Chorus
(Chorus)
This is a stereo chorus. A filter is provided so that you can adjust the
timbre of the chorus sound.
Balance D
L in
Chorus
Chorus
R in
Balance D
Parameter Value
Filter Type
OFF, LPF, HPF
Cof Freq
200–8000 Hz
(Cutoff Freq)
Pre Delay 0.0–100.0 ms
Sync Hz, NOTE
0.05–10.00 Hz,
Rate #
note
Depth
0–127
Phase 0–180 deg
Low Gain
-15–+15 dB
High Gain -15–+15 dB
D100:0W–
Balance #
D0:100W
Level 0–127
2-Band
L out
EQ
Balance W
Balance W
2-Band
R out
EQ
Explanation
Type of filter
OFF: no filter is used
LPF:
cuts the frequency range above
the Cutoff
HPF:
cuts the frequency range
below the Cutoff
Center frequency when using the
filter to cut a specific frequency
range
Adjusts the delay time from the
direct sound until the chorus sound
is heard.
Hz:
The Rate value is specified in Hz.
NOTE: The Rate value is specified as
a note value.
Rate of modulation
Depth of modulation
Spatial spread of the sound
Amount of low-range boost/cut
Amount of high-range boost/cut
Volume balance between the direct
sound (D) and the chorus sound (W)
Output volume
23: Flanger
(Flanger)
This is a stereo flanger (The LFO has the same phase for left and
right.).
It produces a metallic resonance that rises and falls like a jet
airplane taking off or landing.
A filter is provided so that you can adjust the timbre of the flanged
sound.
L in
Flanger
Feedback
Feedback
Flanger
R in
Parameter Value
Filter Type OFF, LPF, HPF
Cof Freq
200–8000 Hz
(Cutoff Freq)
Pre Delay 0.0–100.0 ms
Sync Hz, NOTE
0.05–10.00 Hz,
Rate #
note
Depth 0–127
Phase
0–180 deg
Feedback # -98–+98%
Low Gain -15–+15 dB
High Gain -15–+15 dB
D100:0W–
Balance #
D0:100W
Level
0–127
33
Balance D
2-Band
L out
EQ
Balance W
Balance W
2-Band
R out
EQ
Balance D
Explanation
Type of filter
OFF:
no filter is used
LPF: cuts the frequency range above
the Cutoff
HPF: cuts the frequency range
below the Cutoff
Center frequency when using the
filter to cut a specific frequency
range
Adjusts the delay time from the
direct sound until the flanger sound
is heard.
Hz: The Rate value is specified in Hz.
NOTE:
The Rate value is specified as
a note value.
Rate of modulation
Depth of modulation
Spatial spread of the sound
Adjusts the proportion of the flanger
sound that is fed back into the
effect.
Negative (-) values invert the phase.
Amount of low-range boost/cut
Amount of high-range boost/cut
Volume balance between the direct
sound (D) and the flanger sound (W)
Output volume
Effects