Network Settings - GE SymDec 4 User Manual

20 SymDec 4
User Manual
Figure 12. Configuration page
On this page you can remotely modify the following settings of the SymDec 4:
• Network settings including the IP Address, Subnet Mask, and Gateway Address.
• Streaming settings including setting the unit as a sender or receiver and streaming mode.
• Camera MPEG quality settings.
• What display options to view.
• Password settings.
• Email settings.
• Network Time Protocol settings.
• Factory reset

Network Settings

This page provides an alternate method of changing the SymDec 4's IP addresses. You can also enable DHCP
(Dynamic Host Configuration Protocol) and assign your unit a hostname. DHCP is an Internet protocol for
automating the configuration of devices that use TCP/IP. DHCP can be used to automatically assign IP
addresses. There is also a field for changing the listen port and a field for entering an Ethernet password.
Note: I f you change the listen port from the default, make sure you also change the remote port setting on the SymBrowser
page to the same port number.