Streaming Settings For Udp Multicast - GE SymDec 4 User Manual

24 SymDec 4
User Manual
at 192.168.10.40 The IP address of the receiver. Once these settings are saved on their respective web pages the
SymNet will begin sending streaming video (once requested) and the SymDec 4 will begin receiving streaming
video.
All the settings on the Advanced Streaming settings must match between the sender and the receiver.
In this configuration both the SymDec-1 and SymDec 4 are able to receive a video stream from the SymNet or
SymVeo IP Camera.
Figure 15. SymDec 4 setup as receiver and SymNet setup as sender

Streaming Settings for UDP multicast

Figure 16 illustrates streaming settings for a UDP multicast from the SymNet to the default multicast address.
The default multicast address is 230 for the first field and the balance being the unit's current IP address.
The SymDec 4 is setup as a receiver in Normal mode with the Receiver Cam Map IP address set at
192.168.10.20 (The IP address of the sender) and Use default Multicast Address checked. The SymNet is setup
as a sender with the mulitcast address set at 230.168.10.20. Once these settings are saved on their respective
web pages the SymNet will begin sending multicasting video (once requested) and the SymDec 4 will begin
receiving streaming video.