Main Menu / Sequencing - GE SymDec 4 User Manual

The clock will only be automatically adjusted once on a given time and date. If you manually set the clock
back before the last DST change, the time will not get automatically adjusted again for that same time change.
Main Menu / Time/Date / NTPC
Figure 42. The network time protocol setup menu
Use this menu to enable/disable and specify how often time synchronization should occur between the
SymDec 4 and the Network Server. The Region /Time Zone must be setup prior to enabling the option.
Update Interval, Select from: Disable, Once per Day, Twice per Day, and Once per Hour
NTP Primary Server: Enter IP Address of Primary Server.
NTP Backup Server: Enter IP Address of Backup Server.
1. To save changes and exit the menu: Select [OK], then click the Enter button.
2. To exit the menu without making changes: click the Menu button, or select [CANCEL], and then
click the Enter button.

Main Menu / Sequencing

The dwell time is the amount of time each camera is displayed on-screen (while sequencing) before advancing
to the next camera.
Figure 43. The sequencing menu
Main Menu / Sequencing / Fullscreen Dwell
Use the arrow buttons to change the desired dwell time (from 1 to 30 seconds).
The default is 3 seconds.
45