For Vigor2710Vdn - Draytek Vigor2710 Series User Manual

1 . 2 . 4 F o r V i g o
1 . 2 . 4 F o r V i g o
Vigor2710 Series User's Guide
r 2 7 1 0 V D n
r 2 7 1 0 V D n
LED
ACT
(Activity)
WLAN
DSL
LAN
1/2/3/4
USB
DECT
Phone
Line
WPS
DECT
Pairing/Pag
ing / WPS
Button
Status Explanation
Blinking The router is powered on and running
normally.
Off The router is powered off.
On Wireless access point is ready.
Blinking It will blink while wireless traffic goes
through.
On The router is ready to access Internet
through DSL link.
Blinking Slowly: The modem is ready.
Quickly: The connection is training.
On The port is connected.
Off The port is disconnected.
Blinking The data is transmitting.
On A USB device is connected and active.
Blinking The data is transmitting.
On DECT phone is in use
Off DECT phone is idle or off.
Blinking A DECT phone call comes.
On The phone connected to this port is
off-hook.
Off The phone connected to this port is
on-hook.
Blinking A phone call comes.
On A PSTN phone call comes (in and out).
However, when the phone call is
disconnected, the LED will be off about
six seconds later.
Off There is no PSTN phone call.
On The WPS is on.
Off The WPS is off.
Blinking Waiting for wireless client sending
requests for connection or DECT
handset about two minutes.
On
DECT Pairing and WPS: Press and
hold the button for more than 2
seconds then you could try to register
DECT phone with 2710 within 2
minutes.
DECT Paging: Press once. All handsets
will have beep sound, press the button
again or press any key on any handset
will stop the beep sound.
Off The WPS is off.
Blinking Waiting for wireless client sending
requests for connection about 2 minutes.
8