Draytek Vigor2710 Series User Manual page 103

WAN IP Network
Settings
DNS Server IP Address
After finishing all the settings here, please click OK to activate them.
TTL value is set by telnet command.
Default – Click this button to reset to factory setting.
This group allows you to obtain an IP address automatically
and allows you type in IP address manually.
Obtain an IP address automatically – Click this button to
obtain the IP address automatically.
Router Name – Type in the router name provided by ISP.
Domain Name – Type in the domain name that you have
assigned.
Specify an IP address – Click this radio button to specify
some data.
WAN IP Alias - If you have multiple public IP addresses and
would like to utilize them on the WAN interface, please use
WAN IP Alias. You can set up to 8 public IP addresses other
than the current one you are using. Notice that this setting is
available for WAN1 only. Type the additional WAN IP
address and check the Enable box. Then click OK to exit the
dialog.
IP Address – Type in the private IP address.
Subnet Mask – Type in the subnet mask.
Gateway IP Address – Type in gateway IP address.
Default MAC Address
router. You can use Default MAC Address or specify
another MAC address for your necessity.
MAC Address – Type in the MAC address for the router
manually.
Type in the primary IP address for the router. If necessary,
type in secondary IP address for necessity in the future.
93
Type in MAC address for the
Vigor2710 Series User's Guide