Draytek Vigor2710 Series User Manual page 113

P o r t - b a s e d B r i d g e
P o r t - b a s e d B r i d g e
General page lets you set the first PVC. As to set the second PVC line, please click the
Port-based Bridge tab to open Bridge configuration page.
Available settings are explained as follows:
Item
Enable
P1 to P4
Service Type
Add Tag
Priority
Click Clear to remove all the configurations in this page if you do not satisfy it. When you
finish the configuration, please click OK to save and exit this page. Or click Cancel to abort
the configuration and exit this page.
Description
Check this box to enable that channel. Only channel 3 to 8
can be set in this page, for channel 1 to 2 are reserved for
NAT using.
It means the LAN port 1 to 4. Check the box to designate the
LAN port for channel 3 to 8.
Normally, service type is used for the service of video stream
(e.g., IPTV). It can divide the packets from remote control
and from video stream into different PVC. In general, the
protocol used by remote control is IGMP.
Normal – It means that the PVC can accept all packets
except IGMP.
IGMP – It means that the PVC can accept packets of IGMP
only.
To identify the usage of PVC, check this box to invoke this
setting. And type the number for VLAN ID (number).
To add the packet priority number for such VLAN. The range
is from 0 to 7.
103
Vigor2710 Series User's Guide