Draytek Vigor2710 Series User Manual page 101

WAN Connection
Detection
MTU
RIP Protocol
Bridge Mode
WAN Backup Setup
Encapsulating Type - Drop down the list to choose the type
provided by ISP.
VPI - Type in the value provided by ISP.
VCI - Type in the value provided by ISP.
Modulation – Drop down the list to choose a proper
modulation for the router.
VLAN Enable - Enable the function of VLAN with tag. The
router will add specific VLAN number to all packets while
sending them out. Please type the tag value and specify the
priority for the packets sending by the router.
VID– Type the value as the VLAN ID number. The range is
form 0 to 4095.
Priority – Type the packet priority number for such VLAN.
The range is from 0 to 7.
Such function allows you to verify whether network
connection is alive or not through ARP Detect or Ping
Detect.
Mode – Choose ARP Detect or Ping Detect for the system
to execute for WAN detection.
Ping IP – If you choose Ping Detect as detection mode, you
have to type IP address in this field for pinging.
TTL (Time to Live) – Displays value for your reference.
TTL value is set by telnet command.
It means Max Transmit Unit for packet. The default setting is
1442.
Routing Information Protocol is abbreviated as RIP
（RFC1058）specifying how routers exchange routing tables
information. Click Enable RIP for activating this function.
If you check this box to invoke the function, the router will
work as a bridge.
Dial Backup Mode - If you install a 3G USB modem on the
router, choose the 3G USB Modem to perform WAN backup
via USB device. Then, click the 3G USB Modem Backup
link to access into the following page for configuring detailed
settings.
91
Vigor2710 Series User's Guide