Table of Contents
Advertisement
Figure 8
DNS Configuration
5. Next to the
Obtain configuration from DHCP server
radio button.
6. Click
OK
To manually set the DNS servers to be used by
the DataSafe NAS
1. On the primary menu bar, click
2. On the Network Setup page, click
3. From the
network connection to modify.
Tasks
4. On the
5. Next to the
on page 31), select the
radio button.
6. Enter the appropriate server name in the box next
to the
Add
7. To add another DNS server, repeat step 5.
8. When you are finished adding DNS servers, click
OK
.
Note:
If the IP address is set to be obtained from
DHCP, and you set DNS manually, the system
will accept the manual input, and the
properties on the DataSafe NAS will
automatically be set to
manually
Configuration
Selection
page will still show DHCP as the source of the
IP address. You can go back into the
settings
manual configuration has been saved.
DataSafe NAS User's Manual
Configuration
option, select the
.
Object Selection
table, select the
DNS
list, select
Configuration
option (see Figure 8
Configure manually
button, then click
Add
Configure
. However the
Current
column of the
table on the
Network Adapters
properties page to confirm that the
Network Setup
.
Interfaces
.
.
.
Object
DNS
31
Advertisement
Chapters
Table of Contents
