Ip Settings - Iomega DataSafe Network Device User Manual

IP Settings

Each computer on the network must have a unique IP
address to send and receive data. You can use the
Address Configuration
DataSafe NAS automatically obtain the IP address
configuration from the Dynamic Host Configuration
Protocol (DHCP) server. You can also configure the
address(es) manually.
In addition, you can use the
Configuration
gateway addresses. (A gateway address is the
address of a local IP router on the same network as
the DataSafe NAS that is used to forward traffic to
destinations beyond the local network.) The value in
each field must be a number from 0 through 255.
Note:
Changing the IP address may cause the client
to lose its connection with the DataSafe NAS.
To reconnect, the user must either use the new
IP address or wait until the DNS server is
updated.
To automatically set or change the IP settings
1. On the primary menu bar, click
2. On the Network Setup page, click
3. On the Object Selection
network connection to modify.
Tasks
4. On the
The IP Address Configuration page (Figure 7) dis-
plays.
DataSafe NAS User's Manual
screen to have your
IP Address
screen to specify one or more
Network Setup
table, select the
IP
list, select .
IP
.
Interfaces
.
27