Tektronix Phaser 340 Service Manual page 56

2
Installing the Printer and Drivers
Table 2-1 Configuration page settings (cont'd.)
Parameter Description
Trap Hosts A list of hosts, one for each protocol,
which are able to receive traps.
Private Hosts A single node address per protocol of
a host which is able to set SNMP
variables.
Authentication If enabled, the printer sends a trap for
Failure Traps SNMP authentication failure.
SCSI Disk Indicates if a SCSI disk is attached to
the printer. Also indicates its storage
capacity and the amount of free space.
Execute Determine whether or not to run the
Sys/Start Job system start file during system
initiation.
Boot Delay Number of seconds the printer waits
before booting up the attached hard
drive.
Check parity If true, data parity should be checked.
Disk Address SCSI address of disk for the SCSI
communication channel.
Printer address SCSI address of printer when it is the
initiator.
2-20 Phaser 340 Color Printer
Saved Default
in
NVRAM
yes None
yes None
yes Enabled
Not connected
Yes Run
Yes 0
False
No disk-dependant
No 7
Limits or alternate choices
None,
N.N.N.N /Public,
N.N.N.N/ Proxy,
N.N.N.N/ Private,
N.N.N.N/ Regional,
N.N.N.N/ Core
List of IP addresses of the
form N.N.N.N
Disabled
On-line, total space, free
space. Uninitialized.
Skip
Any positive integer.
True
0 to 6