Tektronix Phaser 340 Service Manual page 206

8
Field Replaceable Unit Disassembly/Assembly
Figure 8-16
8-28 Phaser 340 Color Printer
6. Loosen the transfix gear position sensor.
7. Remove the E-ring securing the transfix gear in place. Then remove
the gear.
8.
Remove the screw (below the transfix gear's shaft) securing the left
side of the paper preheater to the engine frame.
9. Remove the paper preheater drive belt from the left end of the paper
preheater's feed roller.
10.
Remove the five screws securing the left side of the drum/transfix
assembly to the print engine. Note that one screw is removed with a
hex key.
Disconnect wiring
harness
Hex key
screw
Remove
transfix
gear
Remove
transfix gear
position sensor
Removing the drum/transfix assembly (left side)
9100-47