Tektronix Phaser 340 Service Manual page 155

4. Configure SoftPC's PC Serial Ports. Set COM1 to the Modem Port.
Flow control does not need to be checked.
5. In the same pull down menu, set PC Memory to Expanded
Memory of 0 MB and an Extended Memory of 1 MB.
Figure 6-3 Configuring SoftPC's Serial Port
6. To install the diagnostics from the diskette onto your computer: type:
A:INSTALL<return>. A message prints on your screen detailing the
options and method for installing the two available diagnostic sets:
Version 1.xx (for printers serial-numbered B0xxxxx to BBxxxxx) and
Version 2.xx (for printers serial-numbered BCxxxxx and up).
7. Connect to the directory containing the desired version diagnostic
software. Launch the diagnostics program by typing DIAGS. Once
launched, the program repeatedly attempts to communicate with the
printer. The link status indicator, in the bottom-right corner of the
screen, reads "NO" until this link is established; once communication
is established, it reads "ok."
Troubleshooting
Service Manual 6-29
6