Figure 8-28 Removing The Pick Roller - Tektronix Phaser 340 Service Manual

8
Field Replaceable Unit Disassembly/Assembly

Figure 8-28 Removing the pick roller

8-48 Phaser 340 Color Printer
8. Slide the pick roller to the left to free the right end of the shaft. Slide
the right end of the shaft out the large hole above the maintenance
tray guide; you may need to push up on the drum belt to clear it. The
left end of the pick roller shaft can be pulled forward to remove the
pick roller.
Paper path
drive gear
E-ring
Feed roller
drive gear
E-ring
Paper pick
clutch
I/O board 1
Caution
After reinstalling I/O board 1, before turning on the printer, you
should always make sure that the head tilt cam gear is latched by
the head tilt solenoid and that the head tilt cam gear is disengaged
(via its missing teeth) to the drive gear.
Feed roller
E-ring
Bushing
clutch
Bushing
Pick
roller
E-ring
9100-57