Tektronix Phaser 340 Service Manual page 45

7. Install the printer's maintenance tray and paper tray. Note that when
a new maintenance tray is installed, the printer requires a 15-minute
wait before it will print.
8. Installing RAM SIMMs
includes 8 Mbytes of RAM. This can be supplemented with a 4- or
16-Mbyte RAM SIMM. To install the optional memory, refer to the
Chapter 8 topic, "RAM SIMM" on page 8-61.
9. Installing a network card
optional Phaser Share Network Interface plug-in cards.
The LocalTalk/Serial Card supports AppleTalk/LocalTalk protocols
and RS-232 serial connectors.
The Ethernet Interface Card supports the EtherTalk, Novell NetWare,
and TCP/IP protocols.
The Token Ring Network Card supports Novell NetWare, TokenTalk
and TCP/IP protocols.
To install a network card, refer to the Chapter 8 topic, "Network card"
on page 8-63.
10. Following RAM SIMM or network card installation, turn on the
printer to ensure that the card works properly. The printer executes a
power-up self-test and prints a startup page. If the printer fails its
self-test, refer to Chapter 6, "Troubleshooting." The printer can take
up to 15 minutes to warm up from a cold start.
11. Turn off the printer and connect the printer to a host.
Installing the Printer and Drivers
. The standard configuration of the printer
. Network support is provided via three
Service Manual 2-9
2