Block A Route Section - Becker MAP PILOT Operating Manual

>>> NAVIGATION MODE
Display route list
You can have the route displayed on a list.
> D
> When the entire route is displayed,
> GB
select
Route list
> F
> I
> E
> P
The route list is displayed.
> NL
Set route options.
> DK
You can set the route options.
> When the entire route is displayed,
> S
select
Options
> N
> Select
Route options
> Configure
the
> FIN
described under "Route options" on
page 45.
> TR
After any modification, the route will be
> GR
recalculated.
> PL
> CZ
> H
> RUS
40
Simulate route
You can start a simulation of the route.
> When the entire route is displayed,
.
> Select
The route is simulated at four times the
usual speed.
By pressing the
brought to the next action event.
By pressing the
simulation is stopped.
.
.
route options as
select .
Options
.
Simulation
button you are
C
L button, the

Block a route section

You can block a section of the route
ahead. You thereby set specific sections
that should not be driven. From Becker®
MAP PILOT, a detour calculation will be
attempted.
Note:
• Destination navigation is stopped
during section selection.
• The maximum length of a section is 31
mi. (50 km)
• During the section selection, you can
go back to the current point by
L
pressing the button.
> In the route menu, select
Block ahead
.