Connectors Configurations; 2-6.1 On Board Fan Connector (Fan1, Fan2, Fan3, Fan4) - SOLTEK SL-75ERV User Manual

2-6 Connectors Configurations

• This section lists out all connectors configurations for users' reference.

2-6.1 On Board FAN Connector (FAN1, FAN2, FAN3, FAN4)

1 3
FAN1
SOCKET A
PCI 1
AC'97
1 4 JCD_IN1 PCI 2
Codec
PCI 3
LPC I/O
PCI 4
Controller
1 3
PCI 5
WOL1
PCI 6
CNR1
These fan connectors support CPU/System/chassis cooling fan with +12V.
When connecting wire to FAN connectors, users should pay attention
that the red wire is for the positive current and should be connected to
pin +12V, and the black wire is Ground and should be connected to pin
GND. If your mainboard has Hardware Monitor chipset on-board, you
must use a specially designed fan with speed sensor to take advantage
of this function.
For fans with speed sensors, each rotation of the fan blades will send out
2 electric pulses, by which System Hardware Monitor will work out the
fan rotation speed by counting the pulses.
NOTE:
1. Always consult vendor for proper CPU cooling fan.
2. CPU FAN supports the FAN control. You can install PC Alert utility.
This will automatically control the CPU FAN speed according to the
actual CPU temperature.
3. 2"Yellow" fan connectors are used on this series to mark that they
support fan speed sensor function. The other 2 white fan connectors
do not support sensor function.
RT1
VIA
VT8366A
AGP 4X
VIA
VT8233A
1 3
JBAT1
16
1 3
FAN4
1 USB3
27
Chapter 2 Hardware Setup
GND
+12V
SENSOR
On-Board FAN Connectors
CPU FAN1
CPU FAN2
SYSTEM FAN
CHASSIS FAN
FAN1
FAN2
FAN3
FAN4