Checking/Setting System Parameters - NEC VERSA LX Service And Reference Manual

Checking/Setting System Parameters

See the following table for a list of parameters, their factory default settings, and
alternate settings. A description of each setting follows the table.
To reset all parameters to the default settings, select Auto Configuration with
Defaults from the BIOS Setup Main Menu and highlight Yes and press
Parameter
Standard CMOS Setup
Date
System Memory
System Time
Diskette Drive A
1,8
Diskette Drive B
Internal
32-Bit Mode
VersaBay
32-Bit Mode
1
Docking Station IDE
1
DS Internal
1
DS VersaBay
Boot Sector Virus Protection
Advanced CMOS Setup
Video Out Type
LCD Panel View Expansion
PS/2 Port Warm Swap
Internal Mouse
Graphics Aperture Size
System Security Setup
Change Supervisor
Password
Change User Password
Boot Password Required
Resume Password Required
2-14 System Configuration and Setup
BIOS Setup Parameters
Default Setting
mm/dd/yyyy
hh/mm/ss
1.44 MB, 3.5 inch
Not installed
Auto
On
Auto CDROM
On
Auto
Auto
Auto
8
Disabled
NTSC
On
Enabled
Enabled
8
256 MB
Press Enter
2
Press Enter
3
No
3
No
Enter
Alternate Setting(s)
(automatically detected)
Not installed/1.44 MB
1.2 MB, 5.25; 1.44 MB, 3.5 inch
User Defined, CDROM
SuperDsk, Not installed
Off
User Defined, CDROM
SuperDsk, Not installed
Off
User Defined, CDROM
SuperDsk, Not Installed
User Defined, CDROM
SuperDsk, Not Installed
User Defined, CDROM
SuperDsk, Not Installed
Enabled
PAL
Off
Disabled
Disabled
4 MB, 8 MB, 16 MB, 32 MB,
64 MB, 128 MB
Yes
Yes
.