Using Keys; Checking/Setting System Parameters - NEC Versa 2400 Series User Manual

Using Keys

The following table lists Setup keys and their functions.
KEY WHAT IT DOES
← →
Chooses a selection from the menu bar.
Home/End Moves to the first/last parameter on the current screen.
PgUp/PgDn Displays the previous/next page of the current screen if
scrollable.
↑ ↓
Moves the cursor between the displayed parameters.
Enter Displays additional fields for parameters marked with a
Tab For some parameter settings, moves the cursor between the
subfields. For example, for System Time, Tab moves the
cursor from hour to minute to second.
Selects the next lower/higher setting. (Same as F5/F6.)
–/+
F5/F6
Selects the next lower/higher setting. (Same as
F9 Selects the default settings for the displayed parameters only.
F10 Selects the settings of the displayed parameters as they were
upon entering the screen.
Esc Displays the Exit screen.
F1 Displays the General Help screen.

Checking/Setting System Parameters

See the following table for a list of parameters, their factory
default settings, and alternate settings. As you set each pa-
rameter, its available settings are explained in the Item-
Specific Help area in the right part of the screen.
Reset the parameters on the displayed screen to their factory
default settings by pressing
selecting Set Default Values on the Exit screen.
3-4 Using Setup and Power Management
Setup Key Functions
. Or, reset all parameters by
F9
.
–/+.)