Boot Device Setup - NEC VERSA LX Service And Reference Manual



T
LCD Suspend/Resume — Allows you to suspend/resume when the LCD
panel is opened and closed.
T
Suspend Option — Allows you to specify either Suspend or Save to File
(STF) as the default power management mode. In Suspend, after a
specified amount of inactivity, your NEC Versa shuts down all devices as
you specified in Power Management Setup or applies default timeouts.
All your data is automatically recovered from where you left off when
you Resume.
T
Automatic STF — After 30 minutes in Suspend mode, the current file is
automatically saved to a special file on the hard disk and the system shuts
down. To resume, you must press the power button. The system reads the
saved file and sets up your system accordingly.
The save-to-file area is present on your hard drive, pressing the
Fn-Power/Sleep
(Before using the Power/Sleep button to put the system into Suspend
mode set the System Switch BIOS parameter to Sleep button.) For details
about creating the save-to-file area, see the section later in this chapter,
"HDPREPEZ Utility."
T
Panel Brightness — Lets you select the LCD screen brightness.
T
Suspend Warning Tone — Specifies whether the system warning tone
sounds when Suspend mode starts. It is best to keep this option enabled.
T
Remote Power On — Lets you choose whether the system resumes
automatically when an external serial modem receives a ring signal.
T
Resume Signal — Lets you select the signal that generates a modem ring
resume.
T
Modem Ring Resume — Lets you choose whether the system resumes
automatically when an internal serial modem receives a ring signal.
T
Wake Up from Suspend Alarm/Resume Alarm Time — Lets you set a
resume time from Suspend mode.

Boot Device Setup

Boot Device Setup allows you to define the following functions.
T
Quick Boot — Specifies whether or not the system performs all tests
during system boot.
Standby Timeout — Allows you to select the system standby timeout
period.
Auto Suspend Timeout — Defines how much time elapses from the
time the system enters Standby mode to the time the system
automatically enters Suspend Mode.
key combination puts the system into Save to File mode.
System Configuration and Setup 2-19