Checking/Setting System Parameters - NEC SX Service And Reference Manual

Checking/Setting System Parameters

See the following table for a list of parameters, their factory default settings, and
alternate settings. A description of each setting follows the table.
To reset all parameters to the default settings, select Auto Configuration with
Defaults from the BIOS Setup Main Menu and press
Parameter
Standard CMOS Setup
System Date
System Memory
System Time
Diskette Drive A
1
Diskette Drive B
Internal
1
VersaBay
1
DS VersaBay
1
DS Internal
Advanced CMOS Setup
LCD Panel View
Expansion
PS/2 Port Warm Swap
Internal Mouse
System Security Setup
Change Supervisor
Password
Change User Password
2-14 System Configuration and Setup
BIOS Setup Parameters
Default Setting
mm/dd/yyyy
Auto detect: total memory
shown in MB
hh/mm/ss:
1.44 MB, 3.5
Not installed
Auto
Auto
Auto
Auto
Off
Enabled
Enabled
3
and .
Y Enter
Available Setting(s)
Auto detected
hh/mm/ss:
Not installed
1.2 MB, 5.25-inch
1.44 MB, 3.5-inch
1.2 MB, 5.25-inch
1.44 MB, 3.5-inch
Not installed
Not installed
User defined
Auto
CDROM
LS120
Not installed
User defined
Auto
CDROM
LS120
Not installed
User defined
Auto
CDROM
LS120
Not installed/User defined
CDROM/LS120
On
Off
Disabled
Enabled
Disabled
Enabled