Setup; General Safety Information; Scope Of Delivery; Mounting The Soft Tilt - Invacare SB 755 User Manual

3 Setup

3.1

General safety information

When you receive the product, check the packaging. If the
packaging shows any signs of damage upon delivery, contact the
shipping company.
WARNING!
Risk of injury or damage to property
The assembly and installation must be done by
authorized or trained personnel.
– This Soft Tilt version is specially designed and
must only be used in conjunction with 85 or 90
cm wide Invacare® SB 755 beds.
– Follow instructions carefully. If you have any
question regarding the assembly, contact your
local dealer or Invacare representative.
– If the product shows any sign of damages, do
not use the product. Contact your local dealer or
Invacare representative.
– The electrical equipment of the product must not
be dismantled or combined with other electrical
equipment.
– After each assembly, check that all fittings are
properly tightened and that all parts have the
correct function.
3.2

Scope of delivery

The Soft Tilt is delivered partially assembled in a cardboard box.
Main Parts
A Head end arm of left wing
 Head end arm of right wing
 Main module (pre-assembled unit)
 Foot end arm of left wing
 Foot end arm of right wing
 2 sets: Carriage-bolt, washer and lock nut
 4 sets: Allen-bolt, washer and lock nut
 Control Box
 Hand Control
Textile cover (not show in image)
7
3.3

Mounting the Soft Tilt

Mounting the main module
WARNING!
Risk of injury or damage to property
Holding the main module at wrong parts while lifting,
can cause product damage or injury.
– Only hold the main module at the cover plates of
the wings or the mounting brackets on the base
frame, where the lift here stickers are placed.
– Do not hold on the middle cover plate.
WARNING!
Make sure the bed is connected correctly in the middle
and is leveled (180
1.
a.
On each side of the bed, remove the nut J and bolt K using two
13 mm keys to remove the slats assembly L from the bed, and
keep it available for remounting, when the Soft Tilt is removed
again from the bed.
b.
Additional step only required for dividable beds (SB 755D)
Unscrew and remove the distance stick, located at the cross bar
of the mattress support head section, and keep it available for
remounting, when the Soft Tilt is removed again from the bed.
2.
2.
Place the main module
°
).
 onto the crossbars M, following
IVCMA755221119
Setup