Community Strings & Trap Receivers - Intel NetStructure 470 User Manual

C H A P T E R
LOCATION
Main Menu
Configure Management
Community Strings and . . .
NOTE
These are the traps supported by
the switch:
• Power to the switch was
cycled or reset.
• Link, speed, or other status
changes on a port.
• Authentication failure.
5 Using Local Management
Community Strings & Trap Receivers
Description
Use this screen to send alerts to PCs with SNMP management applications
®
(such as Intel Device View) installed.
Current read community: Sets a password for viewing (not changing) the
switch configuration. The string you define here must match the read
community string defined in the SNMP application. The default read
community string is "public."
Current write community: Sets a password for viewing and changing the
switch configuration. The string you define here must match the write
community string defined in the SNMP application. The default write
community string is "private."
Trap Receiving Stations: When an event occurs, the switch automatically
alerts the SNMP management application by sending a trap to the SNMP
management stations (for example, PCs) defined here.
Station IP address: Displays the IP addresses of PCs with SNMP
applications (such as Intel Device View or LANDesk
Manager) installed.
State: Enables or disables sending of traps to the specified trap
receiver.
Community string: Specifies a string for the trap that matches the
community string defined in the SNMP management application. The
default is "public."
®
Network
75