Installing The Add-In Card(S) On The Riser - Intel ISP1100 Product Manual

Installing the Add-in Card(s) on the Riser

Perform this procedure to install the standard or low-profile add-in cards on the riser card. Refer to
Figure 25 while performing this procedure.
Before you begin, examine the length of the bracket at the end of the add-in card you wish to install
to determine whether it is a standard or a low-profile type. The low-profile card bracket is shorter
than the standard card; approximately 3.11 in. (7.9 cm) compared to approximately 4.75 in.
(12.06 cm) long. The low-profile card fits into the right expansion slot (when facing the front of
the server) and the standard card fits in the left slot.
1. Align the add-in card edge connector (A) with the proper riser connector (B). For example:
2. If the add-in card is a standard type (C), the component side faces down and the add-in card
edge connector mates with the connector on the left side of the riser card when the riser is
pointing toward the back of the server.
3. If the add-in card is a low-profile type (D), the component side faces up and the add-in card
edge connector mates with the connector on the right side of the riser card.
4. The connectors are keyed to mate in only one direction.
5. Firmly press the add-in card(s) all the way into the mating connector on the riser card.
C
46
B
Figure 25. Installing the Add-in Card(s) on the Riser
A
Intel
ISP1100 Internet Server Product Guide
D
OMO9462