Installing The 3.5-Inch Diskette Drive; Installing The Drive In The Mounting Bracket; Installing The 3.5-Inch Diskette Drive In The Mounting Bracket - Intel ISP1100 Product Manual

Installing the 3.5-inch Diskette Drive

This procedure describes how to install the 3.5-inch diskette drive in the server drive bay. Before
proceeding, be sure you are thoroughly familiar with the information in "Before You Begin" at the
front of this chapter.

Installing the Drive in the Mounting Bracket

Perform this procedure to install the 3.5-inch diskette drive in the mounting bracket. Refer to
Figure 18 while performing this procedure.
NOTE
This procedure assumes that the mounting bracket has been removed from
the server chassis and the drive removed from the bracket as described in the
previous "Removing the 3.5-inch Diskette Drive" procedure.
1. Place the diskette drive in the mounting bracket with the component side down and the front
panel facing the front of the mounting bracket.
2. Use a Phillips screwdriver and the four screws (A) removed in the preceding "Removing the
3.5-inch Diskette Drive" procedure (two on each side) to securely attach the mounting
bracket to the drive.
Figure 18. Installing the 3.5-inch Diskette Drive in the Mounting Bracket
38
A
A
OMO9456
Intel
ISP1100 Internet Server Product Guide