Intel ISP1100 Product Manual page 80

removing/installing server components
(continued)
removing the PCI add-in cards, 40
removing the processor, 27
removing the processor chip, 28
removing the processor fan, 29
removing the processor heat sink, 27
removing the rear I/O filler panels, 46
removing the riser and add-in cards, 41
removing the riser card, 44
replacing cover, 26
replacing the backup battery, 48
safety and regulatory requirements, 24
safety compliance, 24
tools needed, 24
warnings and cautions, 21
reset system, 53, 67
resume on ring, 18
riser
add-in card installation, 45
add-in card removal, 42
installation, 45, 47
riser and add-in cards, removal, 41
riser card, removal, 44
S
safety and regulatory requirements, 24
safety compliance, 24
serial ports, 15
server, removing/installing components, 21
server board, 8, 9
chipset, 13
components, figure, 9
connectors, 9
Ethernet controllers, 17
fan support, 20
hardware monitor, 16
I/O controller, 15
IDE support, 14
IDE support, 14
memory, 11
power connector, 19
processors, 11
real-time clock, CMOS SRAM, and battery,
14
resume on ring, 18
SCSI hard drive LED connector, 17
SMI and NMI routing, 19
speaker, 19
80
USB, 13
wake on LAN, 17
wake on ring, 18
service, no user-serviceable parts, power
supply, 22
Setup, changing configuration, 53
SMI, 19
SMI and NMI routing, 19
soft boot, 67
speaker, 19
switches, power on/off, 22
Switches, DC power, 67
reset, 67
system components, 7
server, 7
T - U
tools needed, 24
upgrade Flash utility, 63
USB, 13
utilities
BIOS update, 53
Setup, 53
W
Wake on LAN, 17
Wake on Ring, 18
Warning
components may be hot, 27
disconnect power cords, cables, 22
dispose of lithium battery safely, 48
no user-serviceable parts, power supply, 22
power on/off switch, 22
warnings and cautions, 21
Intel
ISP1100 Internet Server Product Guide