Table of Contents
Advertisement
Manual Installation
All network drivers provided on the Intel Network Drivers Disk can be
installed manually, without the Intel Installation Program. You must copy
the correct driver files to your hard disk and make appropriate changes to
CONFIG.SYS, AUTOEXEC.BAT, and configuration files such as
NET.CFG (for ODI) or PROTOCOL.INI (for NDIS). Manual installation
should only be performed by a system administrator or someone with
equivalent knowledge of the installation process for your network
operating system.
NOTE:
For manual installation of Novell NetWare with VLM (available only under MS-
DOS or Windows 3.x) you must first decompress the VLM files by running the
MS-DOS batch file DCOMPVLM.BAT from the Network Drivers Disk, as follows:
where [ path ] is the directory for NetWare files (usually C:NWCLIENT).
DCOMPVLM will decompress and copy all required files to the designated direc-
tory.
For an overview of the installation process, see the instructions provided
for your network operating system i the alphabetical section of this
chapter. Consult Chapter 3, Configuration Reference, for detailed
information on configuration files and settings. For additional information,
consult your network operating system documentation.
Microsoft LAN Manager
Microsoft LAN Manager (version 2.1)
NDIS 2.0 Driver
1
Run the Intel Installation Program fromt he Installation Disk.
2
Choose Microsoft LAN Manager from the Select Network Operating
System screen.
3
Follow the prompts to complete the Intel segment of the installation.
4
Begin installation of LAN Manager using "setup."
5
When prompted to select the available network adapter driver, choose
"Other Driver."
DCOMPVLM [ PATH ]
Software Installation
41
Advertisement
Table of Contents
Troubleshooting
