Intel NetportExpress PRO User Manual page 102

C H A P T E R 4
Please specify a number between 3 and 15 for the IRQ keyword
The IRQ keyword only accepts decimal numbers between 3 and 15.
Please specify either HALF or FULL for the LINEMODE keyword
The LINEMODE keyword determines the duplex mode of the network. If
the network connection is half-duplex, HALF should be used. If the
network connection is full-duplex, FULL should be used. Do not set the
duplex mode to full unless the network connection is configured this way. If
the keyword is not present, the default is AUTO.
Please specify LOW, MEDIUM, or HIGH for the ERT keyword
The ERT keyword is used to set the Advanced-Lookahead threshhold. This
threshhold determines how long to wait before notifying the host of a
receive event. A lower threshhold is better for slower machines, and a
higher threshhold for faster machines. Laptops with fast processors should
use HIGH. This keyword is ignored if the NOEARLYRX keyword is
present.
Please specify MEMORY or IO for the MODE keyword
The value specified for the MODE keyword must be MEMORY or IO.
The driver is out of memory - decrease the transmit or receive buffer
size
The TXBUFFERSIZE and RXBUFFERSIZE keywords are used to
configure the size of the buffers used by the adapter. These buffers reside in
host memory. If the driver cannot allocate the amount of memory required
by the specified configuration, it will display this error. Using the
RXBUFFERSIZE and TXBUFFERSIZE keywords to reduce the size of the
buffers can alleviate the problem.
The IRQ test failed
The IRQ keyword was used to force a value for the IRQ line, and the
resource validation check failed. Either remove the IRQ keyword and let
the driver automatically determine the IRQ, or disable resource checking by
using the NOCHECK keyword.
96