Table of Contents
Advertisement
C H A P T E R 2
7
Edit the AUTOEXEC.BAT file and add the following lines:
C:\PCTCP\M32APD.COM
C:\PCTCP\ETHDRV.EXE
8
(This step is not required for PC/TCP versions 2.10 and later.) Using a
text editor, add the following lines to your CONFIG.SYS file:
DEVICE=[ PATH ]IPCUST.SYS
DEVICE=[ PATH ]IFCUST.SYS
where [path] is the drive and directory specified at the PC/TCP
installation.
9
Reboot the PC.
10 Change to the directory where your PC/TCP files are stored and run
M32APD.COM by typing: M32APD and pressing Enter.
11 Run the ETHDRV.EXE kernel program supplied with PC/TCP. This
loads the PC/TCP kernel into memory. The packet driver must always
load before the kernel.
12 Continue your server or workstation startup as instructed in the PC/
TCP documentation.
ODI with FTP Software PC/TCP and NetWare
If you need to run Novell NetWare concurrently with FTP PC/TCP,
proceed as follows:
1
Run the Intel Installation Program from the Installation Disk.
2
Choose FTP PC/TCP from the Select Network Operating System
screen.
3
Follow the prompts to complete the Intel segment of the installation.
4
Install PC/TCP according to the instructions in your FTP PC/TCP
manual.
5
(This step is not required for PC/TCP versions 2.10 and later.) Using a
text editor, add the following lines to your CONFIG.SYS file:
DEVICE=[ PATH ]IPCUST.SYS
DEVICE=[ PATH ]IFCUST.SYS
36
Advertisement
Table of Contents
Troubleshooting
