Table of Contents
Advertisement
86 LOADING NDIS DATA LINK...
89 PERFORMING NETBIND...
92 LOADING SCHEDULER...
93 LOADING DNP...
94 LOADING REDIRECTOR...
95 SETTING COMPUTER NAME...
98 NETWORK LOADING COMPLETED SUCCESSFULLY
Use /~# parameter when you run Pathworks SETUP. This will allow you to
see any error messages given by any driver that fails to load.
1
If you hang on error code 83%, the Intel NDIS driver failed to
load. Here are some possible reasons for the failure:
a Interrupt conflict - some machines use INT 5 for a sound card.
Change the ni_irq to 10 or 11.
b Some machines require you to change the default memory
setting. Try using CE00, C800, or D400. Make sure to make the
corresponding changes:
• in the mem parameter line in your PROTOCOL.INI,
• in the memory exclusion of the EMM386.EXE line in your
CONFIG.SYS.
Sample PROTOCOL.INI change:
MEM=0XD400
c Some machines require using the mode=io parameter. Add
mode=io to the Intel section in the PROTOCOL.INI file.
2
If you hang on error code 92%, the NDIS driver loaded properly
but the scheduler failed to load. This is usually because your
interrupt in the PROTOCOL.INI doesn't match the ni_irq line.
Make sure you change the ni_irq line to match the INT you want
to use. This process is described under DEC PATHWORKS in
Chapter 2, Software Installation.
Troubleshooting
105
Advertisement
Table of Contents
Troubleshooting
