Intel PCMCIA Quick Start Manual

I n t e l P C M C I A M o d e m C a r d Q u i c k S t a r t G u i d e

A. Hardware Identification

Connection Diagram:

The diagram below shows the PCMCIA Modem connection:

68-ping

15-ping

PCMCIA laptop connection

phone cable connection

Step 1 - Power off the laptop computer.

Step 2 - Insert the card into the laptop PC card slot.

Step 3 - Align the card properly to steady.

Step 4 - Plug the 15-ping phone cable into the phone cable connection of this card.

Step 5 - Power on the laptop computer.

Installation for Windows 9x

Step 1 - As Windows 9x boots up, it will automatically detect your new Modem. Click "Next" to

continue.

Step 2 - Select the default choice that will search for the best driver for your device and click

"Next".

Step 3 - Insert the driver CD into CD-ROM and select "Specify a location" and the file path

"E:\Driver\win9x", and click "Next".

Step 4 - Click "Next" to accept the INF. file. Windows 9x will start to copy all files from CD-ROM

to your PC hard disk.

Step 5 - Click "Finish" to confirm the installation of the modem.

Step 6 - Click "Next" to continue the installation of "Wave Device for Voice Modem".

Step 7 - Repeat Step 2-5 to complete the total installation.

Table of Contents

Do you have a question about the PCMCIA and is the answer not in the manual?

Page 1 I n t e l P C M C I A M o d e m C a r d Q u i c k S t a r t G u i d e A. Hardware Identification Connection Diagram: The diagram below shows the PCMCIA Modem connection: 68-ping 15-ping...
Page 2 Step 3 - Insert the driver CD into CD-ROM and select the file path “E:\Driver\winnt”, and click “OK”. Step 4 - Highlight “Intel 56K bps PCMCIA(MD5661) Modem” and click “OK”. Step 5 - Click “Next” to continue. Step 6 – Driver installed, click “Finish” to confirm the installation.
Page 3 Installation for Windows XP Step 1 - As Windows XP boots up, it will automatically detect your new Modem as a “Standard PCMCIA Card Modem”. Select “Install from a list or specific location (Advanced)” and click “Next”. Step 2 - Insert the driver CD into CD-ROM and select the file path “E:\Driver\winxp”, and click “Next”.